The Onga Pantera pool pumps have been specifically designed to incorporate features that will provide reliable and efficient pump operation. The new technology wet end design integrates a unique moulded end-shield cover and lip seal protecting the motor from water damage.
Applications:
• Swimming pools from 20,000 litres up to 100,000 litres.
 • Solar heating circuits.
 • Above ground pools.
Features & Benefits
• IP55 (TEFC) motor – with IP55 protection from dust and water the PPP pumps are preserved against elements for many years.
 • Stainless steel motor shaft.
 • Electrical approvals – the PPP series pool pumps have passed all stringent Australian standards AS/ NZS3136:2001 for safety and  is approved for installation within the wetted zone of the pool area, approvals V99108, V02301, V02302.
 • Self-aligning barrel unions – Onga’s unique 5 degrees self-aligning barrel unions make pipe work connection a breeze.
• Plastic Yoke and Lip-Seal – The wet end design integrates a moulded end-shield cover and lip seal,protecting the motor from water damage.
• Mechanical Seal – A heavy-duty 3/4″ 316 Stainless Steel mechanical seal (on all models) provides extended life and longer intervals between servicing.
Operating Conditions
Suitable for pumping clean non-aggressive liquids without solids or fibers in suspension.
3 year limited warranty.

Fluid	Water
Maximum working pressure	295 kPa
Water (Swimming Pool) temp range	5ºC-35ºC
Ambient temperature	50ºC maximum

 

MOTOR
Type	TEFC 2 pole continuously rotated
Nominal speed	2800 rpm
IP rating	IP55
Insulation class	Class F
Thermal overload	Inbuilt auto reset
Temperature rise	Class B
Frequency	50Hz
Voltage	230º-240º
Bearing type	Deep groove ball bearing with double contact lip seal
Bearing temperature rating	150ºC

 

MATERIAL
Component	Material
Pump casing	20% glass filled with ABS
Clacker	20% glass filled with polycarbonate
Impeller	20% glass filled with ABS
Baffle	20% glass filled with ABS
Drain plug	20% glass filled with ABS
Diffuser	20% glass filled with ABS
Basket	Polypropylene
Shaft sleeve	Nylon
Motor shaft	400 series stainless steel
End shield	Powder coated cast iron
Hair and lint pot O-ring	Low friction nitrile
Cord/Plug	Nitrile
Mechanical seal, 1/2″ type 6 (LTP1100 = type 6 3/4″
Flexible bellows	Nitrile
Stationary face	Ceramic
Rotating face	Carbon
Spring	18-8 stainless steel

 

Pump Model	A	B	C	D	E	F
PPP550	630	487	121	185	288	290
PPP750	630	487	121	185	288	290
PPP1100	630	495	144	185	288	290
PPP1500	630	495	144	185	288	290
PPP1500H	630	495	144	185	288	314

Note: Dimension ‘E’ an additional 160mm clearance height required above the pump to remove strainer basket for maintenance and cleaning purposes. Unless otherwise specified, all dimensions in mm. Fixing holes accept 8mm fasteners.

Attachments

Argon Onga Pantera PPP Manual
Argon Onga Pentera PPP Spare Parts